A combination square has a ruled blade that slides back and forth, and an angled handle with a level in it.

You can use this tool to mark off or check for perfect ninety or forty five degree angles.

You can check for both level and plumb by aligning the tool across the top or against the side of your project.

Use the square as a marking gauge by tightening the clamp. Move the square down the wood and mark with your awl. You'll get perfect measurements

Another handy use for your combination square is to measure depth. Simply loosen the clamp and move the blade to the desired depth. Check that you're level and take the measurement.

One other option; take the handle right off and you can use it as a 12 inch ruler.

Lubricants

The old saying goes, the squeaky wheel gets the grease, but what do you do if you have run out of oil...

Measuring Up

Measuring anything can become difficult if you don't know the right methods and tools to use...

Nailing Hints

Sure nails are great for holding things together; it's the getting them in place that can be frustrating...

Sanding Tips

Have you been looking for some easier ways to sand your wood projects...

Screwdriver Tips

Screws hold a lot of things together, but sometimes working with them can drive you screwy...

Staple Guns

Whether it is electric or manual a staple gun will make short work of household jobs from framing to upholstering...

The Wrench

Every well-stocked toolbox needs a wrench or two or ten, anyway, I have the nuts and bolts of this handy tool! There are a couple of basic styles...

Tool Maintenance

If you use your tools as much as I do you know it's important to keep them in good repair...

Using Glue

Looking for some easy ways to use glue for your projects? Here are the answers you need...