|
Basic Tool Kit
As you empower yourself to
become a fixit person, assemble yourself a basic tool kit.
Here's the low-down on what you should have...
Beyond the Basics Tools
Almost everybody has the
basic tools, a hammer, a screwdriver and saw, but there
are some tools beyond the basics that you might want to
consider adding to your collection...
Caulk Types
Caulk can save you money by
filling in gaps around windows, siding and in the bathroom...
Choosing Tools
There are so many great
tools out there, choosing the right ones can be difficult...
Combination Squares
A combination square has a
ruled blade that slides back and forth, and an angled
handle with a level in it...
Cutting Glass
Whether you're framing a
picture or replacing a small windowpane you may have to cut some
glass. Well, don't be intimidated...
Drill Bits
Not exactly sure what drill
bit you need for the job? I have a guide to get you
drilling in the right direction...
Easy Ways to Measure
Getting the correct
measurements is important for any project, but it can get
frustrating...
|
If you have to glue a joint together and don't want the
glue squishing all over, lay the pieces where they need to
be and put some tape over the seam. Then, use a utility
knife to cut a slit in the tape along the joint. Glue the
project. When you clamp it, you can easily wipe the glue
off of the tape, and when it has dried, peel the tape off
and you'll have a nice clean seam. 
To get glue out of a corner joint, flatten out the end of
a drinking straw. The small tool will fit easily into
those joints and the glue is pushed up inside the straw
and out of the way. 
If your glue has dried up in the bottle, add a few drops
of white vinegar to the bottle and stir. It will soften it
up in no time. 
If you have ever been in the middle of a project and the
glue has taken forever to get to the top of the bottle,
here's a tip for you... drill several holes an inch or two
apart along the length of a scrap wood block. You can
store your glue bottles upside down in the holes so that
the glue is always at the tip and ready to go.